RoMac CW Identifier & Tuning Pulser utilizes your present computer's sound card to automatically send your callsign at preset intervals, to insure your stations compliance with FCC regulations.  Also incorporated is a Tuning Pulser aka Pecker, to aid in reducing stress and heat while tuning your amplifier, antenna tuner, etc. Owners of the old Pulser software may use their old license for the new combined Automatic CW Identifier and Pulser software.

The program will run in the windows tray so it will not take up valuable screen real estate.  also available is an option to display a small time to ID clock anywhere on the screen you want.

Select whether to send the CW Id either at the beginning of a transmission or at the end .

You can make sure your station is properly identified while tuning up. You have the option to send the CW Id at the end tuning with the Pulser. No more forgetting to ID properly!

No more programming EPROM's to change callsigns. Just type in your new callsign and you're ready to go. Great for that new vanity call you want in the future.

CW speed speed is fully adjustable from 5 to 40 wpm, ID time interval ranges from 1 to 30 minutes in one second increments, and the tone of the CW note is adjustable from 500 Hz to 1000 Hz.

Choose from three convenient options of when to send you station identification, to ensure your compliance with the FCC regulations.

When used with a compatible interface that uses RTS/CTS serial port transceiver control, once the software starts sending your identification, the process won't be interrupted by you un-keying your transceiver. See the FAQ for specific issues with the West Mountain RigBlaster Pro.

If you don't presently have a sound card interface a complete schematic for a basic yet fully functional interface is included here and in the help files. All parts are available at your local Radio Shack store.

All settings are saved from session to session. All sound card settings are restored when quitting the software. Just start the software running and your station is ready to be compliant with the FCC regulations.

Any sound card that is installed in your system may now be selected independently from the windows default sound device.

The Pulser aka "Pulse Tuner" sends a series of short audio tones with a duty cycle as low as 20% to the audio input of your radio enabling you to tune your amplifier or antenna tuner, without worrying about overheating those expensive amplifier tubes or antenna tuner parts.

Take your time, tuning your amplifier optimally using the RoMac Pulser. Considering the cost of replacing amplifier tubes, the RoMac Pulser is a bargain!

Some "Tuning Pulsers" merely key your radio using the CW jack on your radio. RoMac Pulser sends a series of short audio tones (pulses) to you microphone input. The pulses are also "shaped", so the amplitude of the pulse slopes up to peak amplitude.  This further reduces heat and stress on you expensive amplifier tubes and parts.

The RoMac Pulser is compatible with all transmitters, from Icom, Kenwood, TenTec, Yaesu, Collins, Drake and others. Will work with any amplifier on the market today or any older amplifier.

The speed and duty cycle of the audio tones are both adjustable.  All settings are saved from session to session.